Claverly Bell Pull

Claverly Bell Pull

from 120.00

Our Claverley bell pull is based on an authentic Victorian original. The detailing is truly fantastic, as evidenced by the crackled porcelain ‘PULL’ disc and hand ageing. To remove the difficult task of chasing out brickwork the dish sits ‘inside’ a solid teak back plate. Fitting is relatively easy for any competent DIY enthusiast.

Cast in solid brass, this product is available in aged brass or aged nickel finish. It comes complete with full fitting instructions, fixings, a dust liner (to protect the spring and cord inside the brickwork) and a blanking pulley for inside the house (N.B: It does NOT come with pull cord, other pulleys or the bell but all of these are available separately if required.)

IMPORTANT - Please note that this product requires a minimum of 130mm depth to accommodate the tempered return spring at the rear of the pull. For best results, we recommend that the internal bell is located no more than 3 metres from the pull.

Product checklist:

  • Product codes: Aged brass ( BPcl) , Aged nickel ( BPclN)

  • Faceplate – 830mm square

  • Projection ( in front of brickwork) – 65mm

  • Projection ( into brickwork) – 120mm

  • Minimum recommended depth of brickwork – 130mm

  • All products un-lacquered

  • Boxed weight – 1810g

Material:
Quantity:
Add To Cart